Skip to content
Wichita Window Replacement

Blog · 5 min read

Window Fogging Between Panes in Wichita: Fix It?

By The Wichita Window Replacement Team · Updated 2026-07-26

Fogged double-pane window with a failed seal in Wichita, KS

Fog between your window panes means the seal on the insulated glass unit has failed. It cannot be repaired, but it usually does not require a new window either — replacing the glass unit inside the existing sash runs $150 to $400 when the frame is sound.

Before you do anything else, check the warranty. Insulated glass units frequently carry 10 to 20 year manufacturer coverage, and a surprising number of people pay for a replacement they were entitled to for free.

What actually failed

A double-pane insulated glass unit is two panes of glass separated by a spacer, sealed around the perimeter, with a desiccant packed inside the spacer to absorb any residual moisture. The cavity is usually filled with argon.

Every day that unit breathes. The sun heats it, the air inside expands and pushes on the seal; night comes, it contracts and pulls. Thousands of cycles a year. Eventually the sealant loses its grip somewhere along the perimeter.

Once that happens, humid outside air moves in and out with the cycle. The desiccant absorbs moisture until it is saturated, which is why a seal can fail eighteen months before you see anything. Then the water has nowhere to go, and it condenses on the inside faces of the glass. That is the haze, and the mineral deposits that etch into the glass over time are why an old failure often leaves a permanent ghost even after the water clears.

Why it happens sooner on some windows

Not random. The pattern is consistent.

  • South and west exposures fail first. More heat cycling, more UV on the sealant.
  • Bottom edges fail first, because that is where water sits in the frame channel if the weep holes are blocked.
  • Large units fail earlier than small ones — more area, more pressure change per cycle.
  • Blocked weep holes are a major cause. Those tiny slots at the bottom of the exterior frame drain water out. Painted over or packed with debris, the glass unit sits in standing water and the seal is attacked from below.
  • Altitude changes on units shipped without capillary tubes.

That weep hole point is worth acting on. Take a look at the bottom exterior of your windows this weekend and clear them with a thin piece of wire. Five minutes, and it genuinely extends the life of the glass you have left.

Your four options, priced

Option Cost Honest verdict
Warranty claim $0 to a service fee Always check first
Glass-only (IGU) replacement $150–$400 per unit The right answer most of the time
Defogging service $75–$200 per unit Cosmetic only
Full window replacement $400–$900 vinyl, more for other frames Right when the frame is failing too

On defogging

The process: a small hole is drilled in the glass, the cavity is cleaned, sometimes a drying agent is applied, and a one-way vent is installed. The haze goes away and the view comes back.

What has not happened: the seal has not been restored, the argon is gone permanently, and the cavity is now deliberately vented to outside air. Thermal performance stays reduced. In humid weather the unit can fog again.

It is not a scam — it is a legitimate cosmetic service that costs less than glass replacement, and for a window you plan to replace in three years anyway it is a reasonable stopgap. Just buy it knowing what it is.

When to replace the whole window instead

Glass-only replacement is the default. Replace the entire unit when:

  • The sash or frame has rot, or the sash no longer closes squarely
  • The hardware is failing and parts are unavailable
  • Four or more units in the house have fogged. Same age, same seal chemistry — you are on a conveyor belt, and paying $300 a pop as they fail one per year is worse than doing it properly
  • They are single-glazed or old aluminum-framed and you were going to upgrade anyway
  • The glass is obsolete enough that a replacement unit costs close to a new window

Finding the warranty

Worth twenty minutes before you spend anything.

  1. Look for an etched code in a corner of the glass, or a small metal tag or sticker inside the spacer between the panes. Manufacturers stamp these with a code and often a date.
  2. Check the frame channel. Open the sash and look at the top or side jamb for a label with a model and serial number.
  3. Check your closing documents if the house is newer. Window warranties are frequently in the builder packet nobody has opened since move-in.
  4. Call the manufacturer with the code. Some warranties are transferable to subsequent owners; some cover glass but not labor.

Even a warranty that covers the glass and not the labor turns a $350 job into a $120 job.

While you have someone out anyway

If you are paying for a glass replacement, this is the cheapest moment in the window's life to improve it. Going from clear glass to a proper low-E coating with argon costs modestly more on the unit and changes how the room feels — particularly on a west-facing window. Our energy-efficient windows guide explains which label numbers to specify.

You can also change the glass type at the same time: obscure glass for a bathroom, tempered where code requires it, laminated for a road-facing room where noise is the real complaint.

What you should not bother doing

Do not try to DIY a glass unit swap on a vinyl or clad sash. The glazing beads are unforgiving, the sealant matters, and a mis-set unit fails again in two years. The measurement alone has to be exact — glass shops build to your numbers and will not eat the error.

Do not replace all your windows because one fogged. One failure is one failure. Four is a pattern.

Do not ignore it indefinitely either. A vented, damp cavity degrades the low-E coating and etches the glass, so the longer you wait, the more likely a defog leaves you with a permanent haze.

Wichita Window Replacement handles failed glass units and full replacements across Wichita and south central Kansas — vinyl replacement windows, double-hung units, and energy-efficient upgrades — and we will tell you to call your manufacturer first if we think the warranty covers it. For the bigger decision, see our repair versus replace guide.

Get a free quote → · call (844) 511-2320

Ready for a free quote in Wichita?

Wichita Window Replacement — free estimate, clear scope, no pressure. Use the form on this page or jump to the homepage quote.

Related services in Wichita

Wichita Window Replacement money pages — go straight to the service you need.

  • Energy-Efficient Glass and Low-E Coatings

    Wichita sits in the ENERGY STAR North-Central zone, which asks a window for a U-factor of 0.25 or lower and a solar heat gain coefficient at or under 0.40. Almost nothing already hanging in this city's walls comes close to either number.

  • Vinyl Windows and Insert Frames

    Vinyl is the right product for most of Wichita and the wrong product for a specific part of it, and we will tell you which side of that line your house is on before we quote anything. Getting that wrong is not a small aesthetic quibble.

  • Double-Hung Windows and Tilt Sash

    Double-hung is the window most Wichita callers ask for by name, and in roughly half the houses we visit it is not what the opening in front of us was designed to hold. Wanting one and needing one are different things, and worth separating early.

  • Fiberglass Windows and Narrow Sightlines

    Fiberglass earns its price in one situation that happens to be common in Wichita: an old masonry opening originally glazed in steel, which now needs a modern unit that does not announce itself as one. That is a narrow case, and it is worth paying for.

  • Clad-Wood and Divided-Lite Windows

    Wood is what a good deal of pre-war Wichita actually had, and if your house still has a stained interior trim package that nobody has painted, it is usually the only material that keeps the room intact. Everything else in the room was built to match it.

← Back to Wichita Window Replacement homepage

Frequently asked questions

Why is there fog between my window panes?

The perimeter seal on the insulated glass unit has failed. Moist outside air is now getting into the sealed cavity, the desiccant inside the spacer has absorbed all it can, and the moisture condenses on the inner glass surfaces where you cannot reach it.

Can you fix a fogged window without replacing it?

You can replace the glass unit inside the existing sash for $150 to $400 if the sash and frame are sound. What cannot be repaired is the seal itself. Anything sold as a repair of the original unit is either a glass swap or a cosmetic defogging.

Does window defogging work?

It clears the haze. A hole is drilled, the cavity is cleaned and left vented to outside air. What it does not do is restore the argon fill or the sealed cavity, so the thermal performance stays diminished and the unit can re-fog in humid weather. Treat it as cosmetic, not as a repair.

How much does it cost to replace a fogged glass unit?

Usually $150 to $400 per unit for a standard double-pane in a sound sash, including labor. Large units, tempered glass, obscure glass, grids between panes, and low-E coatings push it higher. Replacing the whole window instead runs $400 to $900 for vinyl.

Is a fogged window still insulating?

Partly. The two panes still create an air gap, so it is better than single glazing. But the argon fill is gone, the cavity is now damp, and the low-E coating can degrade where moisture sits against it. Expect meaningfully reduced performance and continued deterioration.

Are fogged windows covered under warranty?

Very often, and this is the step most people skip. Insulated glass units commonly carry manufacturer warranties in the 10 to 20 year range, some transferable to a new owner. Find the etched code in the spacer or a sticker in the frame channel and call the manufacturer before paying anyone.

Local context

How this applies in Wichita, KS

Every article here is written from window work done in Wichita and south central Kansas, so the numbers reflect local labour, permit and material costs rather than a national average. Your own job can land either side of them depending on access, the condition of what is already there, and the materials you pick — hot-rolled steel casement sections, putty-glazed single lights in steel rebates, projected vents on friction stays.

The way to turn any of this into a real answer is to have someone look at your actual situation. The free estimate is free, itemized and written down, with no deposit and no obligation. Call (844) 511-2320 or start on the Wichita Window Replacement homepage.

Areas Wichita Window Replacement covers

Wichita first, then the surrounding communities of south central Kansas. Each has its own page with local detail rather than a copy of this one:

  • Derby, KS Sedgwick County, population 25,625 at the 2020 census
  • Haysville, KS Sedgwick County, population 11,262 at the 2020 census
  • Park City, KS Sedgwick County, population 8,333 at the 2020 census
  • Bel Aire, KS Sedgwick County, population 8,262 at the 2020 census
  • Valley Center, KS Sedgwick County, population 7,340 at the 2020 census
  • Maize, KS Sedgwick County, population 5,735 at the 2020 census

Or jump to the full list of Wichita services.

More from the Wichita Window Replacement blog

W

The Wichita Window Replacement Team

Licensed window pros in Wichita, KS

Written by the Wichita Window Replacement team — licensed, insured window pros serving Wichita, KS and the surrounding area.

Keep reading

Call Now